- Manufactured from high strength ductile iron
- Hot Dip Galvanized for corrosion protection
- All loads guaranteed with 5:1 Factor of Safety
Product Description
The Type BT clamp is specifically designed to clampto the tapered flanges of Structural I-Beams and steelchannels. The clamp has a recessed upper surfacethat is designed to hold the head of a bolt in placewhile the nut is tightened. The rear section of theclamp is called the tail and is available in two differenttail lengths, these being size 1 and size 2 [seeDimension E on the table below]. By selecting theappropriate tail length and with the use of BeamClamp shims any thickness of steel flange can beconnected. To make selecting the correct tail lengtheasier please refer to Table 2 and 3 on page 17 of the catalog.
Please us the following resources to help you configure BeamClamp
Product Video
The Safe Working Loads are based on assemblies tested in typical conditions.
Model | A Bolt Dia | B | C | D1 | D2 | E | Width | Torque (ft lb) | Tensile SWL (lbs) (per bolt) |
Friction SWL (lbs) (per 4 bolts) |
|
---|---|---|---|---|---|---|---|---|---|---|---|
1 | 2 | ||||||||||
BT G12 | 1/2 | 5/8 | 1 | 5/16 | 1/2 | 3/16 | 1/4 | 1-1/8 | 51 | 1293 | 292 |
BT G16 | 5/8 | 11/16 | 1-1/4 | 3/8 | 11/16 | 1/4 | 5/16 | 1-7/16 | 109 | 2219 | 877 |
BT G20 | 3/4 | 13/16 | 1-3/8 | 7/16 | 13/16 | 1/4 | 3/8 | 1-3/4 | 210 | 3703 | 2473 |
Add 1, 2 or 3 to the product code to indicate the desired tail length. For example, a 5/8” bolt diameter with a 5/16” tail would be product code BT2G16.
Do not exceed the Safe Working Load (SWL) specified
Additional Information
Model | BT |
---|---|
Manufacturer | Kee Safety |
Brand | Beam Clamp |
Material | High Strength Ductile Iron |
Finish | Hot Dip Galvanized |
For Use With | Tapered Flanges |