- Manufactured from high strength ductile iron
- Hot Dip Galvanized for corrosion protection
- All loads guaranteed with 5:1 Factor of Safety
Product Description
The Type BE2 clamp has a flat upper surface that allows a nut to be tightened down, similar to the TypeBB product. However, it has the additional feature of a fully threaded screw at the rear of the product that can be adjusted so the grip range of the product matches the flange thickness being connected. The fully threaded screw can be adjusted with a hexagon socket key. This product is ideal for applications where the flange thickness cannot easily be measured or where the flange thickness may vary throughout a project.The Type BE2 clamp is designed to suit parallel flanges such as wide flange beams and angles. For tapered flanges, please use the Type BK1.
Long packing shims (BF2 and BG2) can be used to increase the clamping range. See page 12 for details. To make selecting the appropriate packing easier please refer to Table 1 on page 16 of the catalog.
Please us the following resources to help you configure BeamClamp
Product Video
The Safe Working Loads are based on assemblies tested in typical conditions.
| Model | A Bolt Dia. (Grade 8.8) |
B (mm) |
C (mm) |
D1 (mm) |
D2 (mm) |
E (mm) |
F (dia.) |
Width (mm) |
Torque (Nm) |
Tnsile SWL (kN) per bolt (5:1 Factor of Safety) |
Frictional SWL (kN) per four bolts (5:1 Factory of Safety) |
|---|---|---|---|---|---|---|---|---|---|---|---|
| BE2G12 | M12 | 26 | 25.5 | 7 | 13 | 6 to 22 | M06 | 28.5 | 70 | 3.72 | 1.3 |
| BE2G16 | M16 | 30 | 31 | 6 | 17 | 7 to 23 | M08 | 36 | 150 | 8.25 | 3.9 |
Do not exceed the Safe Working Load (SWL) specified
Additional Information
| Model | BE2 |
|---|---|
| Manufacturer | Kee Safety |
| Brand | Beam Clamp |
| Material | High Strength Ductile Iron |
| Finish | Hot Dip Galvanized |
| For Use With | Parallel Flanges |
