- Manufactured from high strength ductile iron
- Hot Dip Galvanized for corrosion protection
- All loads guaranteed with 5:1 Factor of Safety
The Type BE1 clamp has a recessed upper surface, similar to the Type BA product, to hold the head of a bolt in place while the nut is tightened. However, it has the additional feature of a fully threaded screw at the rear of the product that can be adjusted so the grip range of the product matches the flange thickness being connected. The fully threaded screw can be adjusted with a hexagon socket key. This product is ideal for applications where the flange thickness cannot easily be measured or where the flange thickness may vary throughout a project. The Type BE1 clamp is designed to suit parallel flanges such as wide flange beams and angles. For tapered flanges, please use the Type BK1.
Long packings (BF2 and BG2) can be used to increase the clamping range, see page 12 for details. To make selecting the appropriate packing easier please refer to Table 1 on page 16 of the catalog.
Please us the following resources to help you configure BeamClamp
The Safe Working Loads are based on assemblies tested in typical conditions.
|Model||A Bolt Dia.
|Tnsile SWL (kN)
(5:1 Factor of Safety)
|Frictional SWL (kN)
per four bolts
(5:1 Factory of Safety)
|BE1G10||M10||20||20||6||/||5 to 20||M06||26||20||2.5||/|
|BE1G12||M12||26||25.5||7||13||6 to 22||M06||28.5||70||3.72||1.3|
|BE1G16||M16||30||31||6||17||7 to 23||M08||36||150||8.25||3.9|
|BE1G20||M20||35||34||11||/||8 to 24||M10||44||290||16.12||11|
|BE1G24||M24||49||49||13||/||10 to 30||M12||53||490||21.1||18|
Do not exceed the Safe Working Load (SWL) specified
|Material||High Strength Ductile Iron|
|Finish||Hot Dip Galvanized|
|For Use With||Parallel Flanges|