- Manufactured from high strength ductile iron
- Hot Dip Galvanized for corrosion protection
- All loads guaranteed with 5:1 Factor of Safety
The Type BC1 and BD1 are designed for hooking over the flanges of angles and channels. The Type BC1 has a recessed upper surface that is designed to hold the head of a bolt in place while the nut is tightened. TheType BD1 has a flat upper surface that allows a nut to be tightened down onto it. The nose of the BC1and BD1 has a rib section that can be removed when clamping thick sections of steel [see Dimension C2 in the table below]. This product is not recommended for frictional applications.
Please us the following resources to help you configure BeamClamp
The Safe Working Loads are based on assemblies tested in typical conditions.
|Product Code||A Bolt Dia||B||C1||C2||D||E1||E2||Width||Torque (ft lb)||Tensile SWL (lbs)
(per 4 bolts)
Do not exceed the Safe Working Load (SWL) specified.
|Material||High Strength Ductile Iron|
|Finish||Hot Dip Galvanized|
|For Use With||Angles|