- Powder-coating can be done in any RAL Color (see the chart)
- Powder-coating adds about two weeks of lead time.
The Type 325 Slope Down Tee will accommodate a 30-45° angle. This fitting allows for a single fitting to join a horizontal handrail to a vertical upright and a sloped handrail extending down from the fitting.
This fitting is commonly used in handrail projects that require a railing to extend from a landing down a set of stairs.
Frequently Asked Questions
Does the fitting come with set screws?
Are these fitting available in colors?
Yes. Kee Klamp, Kee Lite, Kee Access fittings and pipe can be powdercoated to give them a durable baked on paint finish. powder-coating is extremely durable and will give your railing or structure a really sharp look.
Please contact us if you would like to discuss powder-coating with a projects specialist.
What kind of pipe can be used with Kee Klamp and Kee Lite fittings?
Kee Klamp and Kee Lite components are designed to be used with Schedule 40 Pipe (or Schedule 80), but can also be used with other types of pipe or tube.
When acquiring your own pipe and tube it is important to know the actual OUTER DIAMETER of your pipe/tube . Do not assume that just because it says 1 Inch Pipe/Tube for instance, that the outer diameter is actually 1 inch. This mistake frequently results in returns.
If you are purchasing fittings and pipe from our website, match the pipe size with the fitting size such as Size 7 pipe with Size 7 fittings, Size 8 pipe with Size 8 fittings, etc. You may also refer to our SIZING CHART for further help.
How can I be sure I'm ordering the right size fittings?
If you already have pipe, please measure the outer diameter of your pipe and compare it to the chart on this page. For simplicity we have a printable pipe chart that you can use to measure your pipe. Be sure to follow the instructions on the sheet to guarantee an accurate measurement.
If you are purchasing your pipe from us, then be sure to match the size after the dash '-' on the fittings to the size of the pipe. For instance, a 10-7 is a size 7 fitting. Select size 7 pipe to go with that fitting.
|Model||Measurements (in.)||Weight (lbs.)|
|Model||Measurements (mm)||Weight (kgs)|
Pipe Size Chart
The chart below will help you understand how to match the size of fittings and pipe.
|Size / Fits Pipe:||7 / Outside Diameter 1.660"|
|Fits Pipe OD||1.660"|
|Fits Pipe (Nominal Bore)||1-1/4"|
|Loads||A Kee Klamp component (size 5 to 9) can support an axial load of 2000 lbs. per set screw with the set screw tightened to a torque of 29 lbs/ft. (rating includes a safety factor of 2:1)|
|Set Screw||Stainless Steel Hardware|
|Standards||ASTM A47-77-32510, BS EN ISO 1461|
|Alt. Mfgr. Model Number||5A470|